Programming EVA by: Amena

Hii! Today I wanted to use the touch sensor in Ev3. So I set it up next to the colour sensor, then I searched up an online tutorial on how to programme it and how to use it. I found a couple of tutorials and I followed the instructions. After that I wrote my own code so I could test it. I used the switch block to make it move forward when it was released, and make it stop when it's pressed on.


Here is a close up picture of the Touch sensor:


Comments

  1. AnonymousFebruary 27, 2023 at 10:12 PM

    Good job! That's awesome you found how to program it on the internet. So what are doing next?

    ReplyDelete

Post a Comment

What the Ninjas have been up to

Table Design

Image
Today my partner and I, (Foni ) made a table made from paper and cardbord. We twisted 3 peices of paper to creat each leg. A piece of cardbord served as the top. The table, The first book, The other book... Ahhhhhhhhh! Thankfully, the table lived! By Emi
Read more